Brake Actuator: Installation

INSTALL BRAKE ACTUATOR WITH BRACKET
1. Install the actuator with bracket with the 3 bolts.
  Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
  
  NOTE: Do not damage the brake tubes and wire harness.
  
  Fig 1: Locating Actuator With Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the actuator connector.
  
  Fig 2: Connecting Actuator Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST, connect each brake tube to correct positions of the actuator with bracket as shown in the illustration.
  
  Fig 3: Connecting Brake Tube To Correct Positions Of Actuator With Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
SST 09023-00101

Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)
FILL RESERVOIR WITH BRAKE FLUID (See BRAKE FLUID )
BLEED MASTER CYLINDER (See BLEEDING )
BLEED BRAKE LINE (See BLEEDING )
CHECK BRAKE FLUID LEAKAGE
CHECK FLUID LEVEL IN RESERVOIR (See BRAKE FLUID )
CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See CUSTOMIZE PARAMETERS ).
PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
1. Perform the yaw rate sensor zero point calibration (See CALIBRATION ).
CHECK BRAKE ACTUATOR WITH TECHSTREAM
1. Check the brake actuator (See ON-VEHICLE INSPECTION ).