Steering Angle Sensor: Installation
- INSTALL STEERING ANGLE SENSOR
- Install the steering angle sensor to the spiral cable.
NOTE:
- Engage the claws securely.
- Do not damage the claws.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- INSPECT SPIRAL CABLE (See
INSPECTION
)
- PLACE FRONT WHEELS FACING STRAIGHT AHEAD
- INSTALL SPIRAL CABLE (See
INSPECTION
)
- CENTER SPIRAL CABLE (See
INSTALLATION
)
- INSTALL STEERING WHEEL ASSEMBLY (See
INSTALLATION
)
- INSTALL STEERING PAD (See
INSTALLATION
)
- INSPECT STEERING PAD (See
INSTALLATION
)
- INSPECT STEERING WHEEL CENTER POINT
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See
CUSTOMIZE PARAMETERS
).
- Make sure that the cable has been disconnected from the battery terminal for at least 2 seconds before reconnecting the cable.
- Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.
- INSPECT SRS WARNING LIGHT (See
DIAGNOSIS SYSTEM
)