Freeze Frame Data

HINT:

• Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
• The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from off to the on (IG) since the last time the ABS was activated. However, if the vehicle is stopped or at low speed (4.3 mph (7 km/h) or less), or if a DTC is detected, the skid control ECU will stop counting the number.
• Freeze frame data at the time the ABS operates: The skid control ECU stores and updates data whenever the ABS system operates. When the ECU stores data at the time a DTC is detected, the data stored during ABS operation is erased.
• Freeze frame data at the time a DTC is detected: When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.

1. Connect Techstream to the DLC3.
2. Turn the ignition switch on (IG).
3. Select "DTC INFO" on the tester display.
4. On the DTC data display screen, select the DTC data displayed with "*".