Inspection Procedure
- CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0604)
- Connect Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the tester on.
- Clear the DTC.
- Turn the ignition switch off.
- Disconnect the negative battery terminal and wait for 1 minute.
- Connect the negative battery terminal.
- Turn the ignition switch to ON.
- Enter the following menus: Powertrain/Engine/Trouble Codes.
- Read the DTCs.
Result
DTC OUTPUT RESULTDisplay (DTC output) Proceed to P0604 A No output DTC B B: CHECK FOR INTERMITTENT PROBLEMS (See CHECK FOR INTERMITTENT PROBLEMS )
A :REPLACE ECM (See REMOVAL )