LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Land Cruiser >> Repair and Diagnosis >> Body & Frame >> Seats >> Front Seat Assembly >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Seat Assembly: Installation

  1. INSTALL FRONT SEAT ASSEMBLY LH 
    1. Place the front seat assembly in the cabin.
      NOTE: Be careful not to damage the vehicle body.
    2. Connect the seat wire connectors under the seat.
      Fig 1: Identifying Slide And Vertical Power Seat Switch Knob Claws
      G05631677Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the cable to the negative (-) battery terminal.
    4. Temporarily install the front seat assembly with the 4 bolts.
    5. Operate the power seat switch (slide switch) to move the seat to the rearmost position.
    6. Tighten the bolts in the order shown in the illustration.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    7. Operate the power seat switch (slide switch) to move the seat to the foremost position.
      Fig 2: Locating Front Seat Assembly Bolts
      G05631678Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Tighten the bolts in the order shown in the illustration.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

      Fig 3: Locating Front Seat Assembly Bolts
      G05631679Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL REAR INNER SEAT TRACK BRACKET COVER LH 
    1. Attach the 2 claws to install the cover.
    Fig 4: Installing Rear Inner Seat Track Bracket Cover
    G05631680Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH 
    1. Attach the 2 claws to install the cover.
    Fig 5: Installing Rear Outer Seat Track Bracket Cover
    G05631681Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH 
    1. Attach the 2 claws to install the cover.
    Fig 6: Installing Front Inner Seat Track Bracket Cover
    G05631682Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH 
    1. Attach the 2 claws to install the cover.
    2. Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter (See CUSTOMIZE PARAMETERS ).
  6. INSTALL FRONT SEAT HEADREST ASSEMBLY 
  7. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (See DIAGNOSIS SYSTEM ).
    Fig 7: Installing Front Outer Seat Track Bracket Cover
    G05631683Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. INSPECT FRONT SEAT ASSEMBLY 
    1. Check the power seat operation (See OPERATION CHECK  ).
    2. Check the seat heater operation.
      1. Turn the engine switch on (IG).
      2. Turn the seat heater switch on.
      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.
scientia non olet · About LEMON Manuals