Inspection Procedure

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG) and the Techstream on.
4. Select "CAN Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus.

   OK: "CAN Bus Check" indicates no malfunctions in CAN communication. 

NG: GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)  (See HOW TO PROCEED WITH TROUBLESHOOTING )

OK: Go to Next Step 

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG) and the Techstream on.
4. Check for DTCs (See HOW TO PROCEED WITH TROUBLESHOOTING ).

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   CAN system DTC is not output	A
   CAN system DTC is output	B

B: GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)  (See DIAGNOSTIC TROUBLE CODE CHART )

A: Go to Next Step 

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG) and the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Check the condition of the CRAWL indicator light by operating the Techstream.

   Combination Meter 

   ACTIVE TEST - COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat. Lamp CRAWL	CRAWL Indicator Light	Indicator light ON/OFF	-

OK: The indicator light turns on when operating the Techstream. 

NG: REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL )

OK: REPLACE MASTER CYLINDER SOLENOID  (See DISASSEMBLY )