LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Land Cruiser >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Circuit Tests And Service Information >> Engine Coolant Temperature Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Coolant Temperature Sensor: Installation

  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install a new gasket to the sensor.
    2. Using a 19 mm deep socked wrench, install the sensor.

      Torque: 20 N*m (200 kgf*cm, 14 ft.*lbf) 

    3. Connect the sensor connector.
      Fig 1: Locating Engine Coolant Temperature Sensor
      G05628270Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. ADD ENGINE COOLANT  (See REPLACEMENT )
  3. INSPECT FOR COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  4. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH  (See INSTALLATION )
  7. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH  (See INSTALLATION )
scientia non olet · About LEMON Manuals