Heated Oxygen Sensor: Installation

INSTALL NO. 2 HEATED OXYGEN SENSOR (Bank 1 Sensor 2)
1. Temporarily install the sensor to the exhaust pipe by hand.
  
  Fig 1: Installing No. 2 Heated Oxygen Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, tighten the sensor.
  SST 09224-00010
  
  Torque: without SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  With SST
  
  40 N*m (408 kgf*cm, 30 ft.*lbf)
  
  HINT:
  - Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See REPAIR INSTRUCTION ).
  - Make sure SST and the wrench are connected in a straight line.
    
    Fig 2: Identifying Torque Wrench Fulcrum Length
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HEATED OXYGEN SENSOR (Bank 2 Sensor 2)
1. Temporarily install the sensor to the exhaust pipe by hand.
  
  Fig 3: Installing No. 2 Heated Oxygen Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, tighten the sensor.
  SST 09224-00010
  
  Torque: without SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  With SST
  
  40 N*m (408 kgf*cm, 30 ft.*lbf)
  
  HINT:
  - Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See REPAIR INSTRUCTION ).
  - Make sure SST and the wrench are connected in a straight line.
    
    Fig 4: Identifying Torque Wrench Fulcrum Length
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL CENTER EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL TAILPIPE ASSEMBLY (See INSTALLATION )
INSPECT FOR EXHAUST GAS LEAK (See INSTALLATION )
INSTALL NO. 2 ENGINE UNDER COVER (See INSTALLATION )