LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Matrix Base, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control/Dynamic Control System >> Anti-Lock Brake System >> Data List / Active Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test

  1. DATA LIST 

    HINT:

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Warm up the engine.
    2. Turn the ignition switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch to ON.
    5. Turn the Techstream on.
    6. Enter the following menus: Chassis / ABS/VSC/ TRAC / Data List.
    7. According to the Techstream display, read the Data List.

      ABS/VSC/TRAC 

      ABS/VSC/TRAC DATA LIST

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ABS Warning Lamp ABS warning light / ON or OFF ON: Warning light ON
      OFF: Warning light OFF      		 -
      Brake Warning Lamp Brake warning light / ON or OFF ON: Warning light ON
      OFF: Warning light OFF      		 -
      Stop Lamp SW Stop light switch / ON or OFF ON: Brake pedal depressed
      OFF: Brake pedal released      		 -
      Parking Brake SW Parking brake switch / ON or OFF ON: Parking brake applied
      OFF: Parking brake released      		 -
      Deceleration Sensor(1) Deceleration sensor/ min.: -18.52 m/s2 , max.: 18.39 m/s2 Approximately 0 +/-0.13 while stationary Reading changes when vehicle is bounced
      Forward and Rearward G(1) Forward and backward G / min.: -25.11 m/s2 , max.: 24.91 m/s2 Min.: -25.11 m/s2
      Max.: 24.91 m/s2      		 -
      FR Wheel Speed FR wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph) Actual wheel speed Similar speed as indicated on speedometer
      FL Wheel Speed FL wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph) Actual wheel speed Similar speed as indicated on speedometer
      RR Wheel Speed RR wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph) Actual wheel speed Similar speed as indicated on speedometer
      RL Wheel Speed RL wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph) Actual wheel speed Similar speed as indicated on speedometer
      Vehicle Speed Maximum wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph) Actual vehicle speed Speed indicated on speedometer
      FR Wheel Acceleration FR wheel acceleration / min.: -200.84 m/s2 , max.: 199.27 m/s2 0 m/s2 -
      FL Wheel Acceleration FL wheel acceleration / min.: -200.84 m/s2 , max.: 199.27 m/s2 0 m/s2 -
      RR Wheel Acceleration RR wheel acceleration / min.: -200.84 m/s2 , max.: 199.27 m/s2 0 m/s2 -
      RL Wheel Acceleration RL wheel acceleration / min.: -200.84 m/s2 , max.: 199.27 m/s2 0 m/s2 -
      FR Wheel ABS Ctrl Status FR ABS control status / ON or OFF ON: During ABS control
      OFF: Not ABS control      		 -
      FL Wheel ABS Ctrl Status FL ABS control status / ON or OFF ON: During ABS control
      OFF: Not ABS control      		 -
      RR Wheel ABS Ctrl Status RR ABS control status / ON or OFF ON: During ABS control
      OFF: Not ABS control      		 -
      RL Wheel ABS Ctrl Status RL ABS control status / ON or OFF ON: During ABS control
      OFF: Not ABS control      		 -
      RR Wheel EBD Ctrl Status RR EBD control status / ON or OFF ON: During EBD control
      OFF: Not EBD control      		 -
      RL Wheel EBD Ctrl Status RL EBD control status / ON or OFF ON: During EBD control
      OFF: Not EBD control      		 -
      Solenoid Relay ABS solenoid relay / ON or OFF ON: Solenoid relay ON
      OFF: Solenoid relay OFF      		 -
      ABS Motor Relay ABS motor relay / ON or OFF ON: Motor relay ON
      OFF: Motor relay OFF      		 -
      ABS Solenoid (SFRH) ABS solenoid (SFRH) / ON or OFF ON: Operating -
      ABS Solenoid (SFRR) ABS solenoid (SFRR) / ON or OFF ON: Operating -
      ABS Solenoid (SFLH) ABS solenoid (SFLH) / ON or OFF ON: Operating -
      ABS Solenoid (SFLR) ABS solenoid (SFLR) / ON or OFF ON: Operating -
      ABS Solenoid (SRRH) ABS solenoid (SRRH) / ON or OFF ON: Operating -
      ABS Solenoid (SRRR) ABS solenoid (SRRR) / ON or OFF ON: Operating -
      ABS Solenoid (SRLH) ABS solenoid (SRLH) / ON or OFF ON: Operating -
      ABS Solenoid (SRLR) ABS solenoid (SRLR) / ON or OFF ON: Operating -
      FR Speed Open FR speed sensor open detection / ERROR or NORMAL ERROR: Momentary interruption
      NORMAL: Normal      		 -
      FL Speed Open FL speed sensor open detection / ERROR or NORMAL ERROR: Momentary interruption
      NORMAL: Normal      		 -
      RR Speed Open RR speed sensor open detection / ERROR or NORMAL ERROR: Momentary interruption
      NORMAL: Normal      		 -
      RL Speed Open RL speed sensor open detection / ERROR or NORMAL ERROR: Momentary interruption
      NORMAL: Normal      		 -
      Number of DTC Number of DTC recorded / min.: 0, max.: 255 Min.: 0
      Max.: 255      		 -
      (1) for 4WD
  2. ACTIVE TEST 

    HINT:

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Warm up the engine.
    2. Turn the ignition switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch to ON.
    5. Turn the Techstream on.
    6. Enter the following menus: Chassis / ABS/VSC/ TRAC / Active Test.
    7. According to the Techstream display, perform the Active Test.

      ABS/VSC/TRAC 

      ABS/VSC/TRAC ACTIVE TEST REFERENCE CHART

      Tester Display Test Part Control Range Diagnostic Note
      ABS Warning Lamp ABS warning light Warning light ON/OFF Observe combination meter
      Brake Warning Lamp Brake warning light Warning light ON/OFF Observe combination meter
      Solenoid Relay ABS solenoid relay Relay ON/OFF -
      Motor Relay ABS motor relay Relay ON/OFF Operating sound of motor can be heard
      ABS Solenoid (SRLR) ABS solenoid (SRLR) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
      ABS Solenoid (SRLH) ABS solenoid (SRLH) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
      ABS Solenoid (SRRR) ABS solenoid (SRRR) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
      ABS Solenoid (SRRH) ABS solenoid (SRRH) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
      ABS Solenoid (SFLR) ABS solenoid (SFLR) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
      ABS Solenoid (SFLH) ABS solenoid (SFLH) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
      ABS Solenoid (SFRR) ABS solenoid (SFRR) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
      ABS Solenoid (SFRH) ABS solenoid (SFRH) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
scientia non olet · About LEMON Manuals