Inspection Procedure
HINT:
- The following conditions may also cause DTC P0505 to be set:
- The floor carpet overlapping slightly onto the accelerator pedal, causing the accelerator pedal to be slightly depressed and therefore the throttle valve position to be slightly open.
- The accelerator pedal being not fully released.
- Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0505)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.
Result
RESULT CHARTResult Proceed to DTC P0505 is output A DTC P0505 and other DTCs are output B HINT:
If any DTCs other than P0505 are output, troubleshoot those DTCs first.
B: GO TO DTC CHART (See DIAGNOSTIC TROUBLE CODE CHART )
A: Go to next step
- CHECK PCV HOSE CONNECTIONS
- Check the PCV hose connections (See
PCV VALVE
).
OK: PCV hose is connected correctly and is not damaged .
NG: REPAIR OR REPLACE PCV HOSE
OK: Go to next step
- Check the PCV hose connections (See
PCV VALVE
).
- CHECK INTAKE SYSTEM
- Check the intake system for vacuum leaks (See
INTAKE SYSTEM
).
OK: No leaks in intake system .
NG: REPAIR OR REPLACE INTAKE SYSTEM
OK: Go to next step
- Check the intake system for vacuum leaks (See
INTAKE SYSTEM
).
- INSPECT THROTTLE BODY ASSEMBLY (THROTTLE VALVE)