SFI System: Precaution
- INITIALIZATION NOTE:
- Perform RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (See INITIALIZATION ).
- Perform REGISTRATION (VIN registration) when replacing the ECM (See REGISTRATION ).
HINT:
Reset memory or initialization cannot be completed by only disconnecting and reconnecting the cable to the negative (-) battery terminal.
- FOR USING TECHSTREAM CAUTION: Observe the following items for safety reasons:
- Read its instruction books before using the Techstream.
- Prevent the Techstream cable from being caught on the pedals, shift lever or steering wheel when driving with the Techstream connected to the vehicle.
- When driving the vehicle for testing purposes using the Techstream, two persons are required. One person drives the vehicle, and the other operates the Techstream.
- DISCONNECTING AND RECONNECTING OF NEGATIVE BATTERY TERMINAL CABLE
- Before performing work on electric components, disconnect the cable from the negative (-) battery terminal in order to prevent damage to the electrical system or components.
- Before disconnecting and reconnecting the battery cable, turn the ignition switch off and the headlight switch OFF. Then loosen the terminal nut completely. Do not damage the cable or terminal.
- When the battery cable is disconnected, the clock and radio settings and stored DTCs are cleared. Therefore, before disconnecting the battery cable, make a note of the settings.