Camshaft Position Sensor: Installation

HINT:

Although the part name refers to the No. 1 crank position sensors, this procedure is for the camshaft position sensors.

Fig 1: Locating Bolt And No. 1 Crank Position Sensor

INSTALL NO. 1 CRANK POSITION SENSOR
1. Apply a light coat of engine oil to the O-rings on the No. 1 crank position sensors.
  
  Fig 2: Locating O-Rings
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Intake camshaft side:
  1. Install the No. 1 crank position sensor with the bolt.
    Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
    
    Fig 3: Locating Bolt And No. 1 Crank Position Sensor
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Connect the No. 1 crank position sensor connector.
    
    Fig 4: Locating No. 1 Crank Position Sensor Connector
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Exhaust camshaft side:
  1. Install the No. 1 crank position sensor with the bolt.
    Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
    
    Fig 5: Locating Bolt And No. 1 Crank Position Sensor
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Connect the No. 1 crank position sensor.
    
    Fig 6: Locating No. 1 Crank Position Sensor Connector
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. Connect the 3 engine wire harness clamps and duty vacuum switching connector.
INSPECT FOR OIL LEAK
INSTALL NO. 2 CYLINDER HEAD COVER (See INSTALLATION )

Fig 7: Locating Engine Wire Harness Clamps
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002