Front Speed Sensor: Installation

HINT:

• Use the same procedure for the RH side and LH side.
• The procedure listed below is for the LH side.
• If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.
  Fig 1: Locating Front Speed Sensor Bolt

  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. INSTALL FRONT SPEED SENSOR 
   1. Install the front speed sensor with the bolt.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

      NOTE:

      • Prevent foreign matter from attaching to the sensor tip.
      • Do not file the hole or the contact surface because the gap between the magnet rotor and front speed sensor is important.
        Fig 2: Locating Front Speed Sensor Bolt

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Install the clamp to the shock absorber.
      Fig 3: Identifying Shock Absorber Clamp

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Temporarily install the No. 1 sensor clamp to the shock absorber.
      Fig 4: Identifying No. 1 Sensor Clamp

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Install the brake flexible hose with the bolt.

      Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf) 

      NOTE:

      • Do not twist the wire harness for the front speed sensor when installing it.
      • Tighten the brake flexible hose and front speed sensor together with the bolt. Make sure that the front speed sensor is positioned over the flexible hose.
        Fig 5: Locating Brake Flexible Hose Bolt

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   5. Install the No. 2 sensor clamp to the body with the bolt.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

      Fig 6: Locating No. 2 Sensor Clamp And Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   6. Connect the speed sensor wire harness clamp.
   7. Connect the speed sensor connector.
2. INSTALL FRONT FENDER LINER  (See INSTALLATION )
3. INSTALL FRONT WHEEL 

   Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
5. CHECK FOR SPEED SENSOR SIGNAL 

   HINT:

   • w/o VSC (See TEST MODE PROCEDURE  )
   • w/ VSC (See TEST MODE PROCEDURE  )
     Fig 7: Locating Front Speed Sensor Connector And Wire Harness Clamp

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002