Inspection Procedure

1. READ OUTPUT DTC (DTC P060D) 
   1. Connect the Techstream to the DLC3.
   2. Turn the ignition switch to ON.
   3. Turn the Techstream on.
   4. Clear the DTC (See DTC CHECK / CLEAR ).
   5. Turn the ignition switch off and turn the Techstream off.
   6. Disconnect the Techstream.
   7. Disconnect the cable from the battery negative (-) terminal and wait for 1 minute.
   8. Connect the cable to the battery negative (-) terminal.
   9. Connect the Techstream to the DLC3.
   10. Turn the ignition switch to ON.
   11. Turn the Techstream on.
   12. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
   13. Read DTCs.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   No output	A
   P060D	B

B: REPLACE ECM  (See ECM )

A: CHECK FOR INTERMITTENT PROBLEMS  (See CHECK FOR INTERMITTENT PROBLEMS )