Inspection Procedure

1. Disconnect the P17 switch connector.
Fig 1: Identifying Power Window Regulator Master Switch Connectors
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the voltage of the wire harness side connector.

   Standard voltage 

   TERMINALS VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   P17-7 (BW) - P17-1 (E)	Always	10 to 14 V
   P17-11 (BDR) - P17-1 (E)	Power switch ON (IG)	10 to 14 V

NG : REPAIR OR REPLACE HARNESS AND CONNECTOR (BATTERY - MASTER SWITCH) 

OK : GO TO NEXT STEP 

1. Disconnect the P17 switch connector.
2. Using a service wire, connect the terminals according to the table below.
Fig 2: Identifying Power Window Regulator Master Switch Connectors
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Check operation of the power window regulator motor.

   OK 

   WIRE CONNECTION AND SPECIFIED CONDITION
   
   

   Wire Connection	Specified Condition
   P17-4 (DU) - P17-7 (BW) P17-9 (DD) - Body ground	Power window moves UP
   P17-4 (DU) - Body ground P17-7 (BW) - P17-9 (DD)	Power window moves DOWN

OK : REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY 

NG : GO TO NEXT STEP 

1. Disconnect the P17 switch connector.
2. Disconnect the P18 motor connector.
Fig 3: Identifying Power Window Regulator Master Switch Connectors
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Measure the resistance of the wire harness side connectors.

   Standard resistance 

   TERMINALS RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   P17-9 (DD) - P18-1 (D)	Below 1 Ω
   P17-4 (DU) - P18-2 (U)	Below 1 Ω
   P17-9 (DD) or P18-1 (D) - Body ground	10 kΩ or higher
   P17-4 (DU) or P18-2 (U) - Body ground	10 kΩ or higher

NG : REPAIR OR REPLACE HARNESS AND CONNECTOR 

OK : REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY FRONT LH