Throttle Body: Installation

INSTALL THROTTLE BODY ASSEMBLY WITH MOTOR
1. Install a new gasket to the intake manifold.
  
  Fig 1: Locating Intake Manifold Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the throttle with motor body with the bolt and 2 nuts.
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
  
  Fig 2: Locating Motor Body Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the throttle position sensor connector.
4. Connect the throttle control motor connector.
  
  Fig 3: Locating Throttle Position Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the No. 2 water by-pass hose.
6. Connect the water by-pass hose.
  
  Fig 4: Locating No. 2 Water By-Pass Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Connect the No. 1 fuel vapor feed hose.
8. Connect the No. 2 ventilation hose.
9. Connect the ventilation hose.
  
  Fig 5: Locating No. 1 Fuel Vapor Feed Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER ASSEMBLY
1. Install the air cleaner with the 2 bolts.
  Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
2. Tighten the hose clamp bolt.
  Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
3. Connect the No. 1 air cleaner inlet, and tighten the hose clamp bolt.
  Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
4. Connect the MAF meter connector.
  
  Fig 6: Locating Hose Clamp Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADD ENGINE COOLANT (See COOLANT )
INSPECT FOR COOLANT LEAK (for Engine) (See ON-VEHICLE INSPECTION )
INSTALL ENGINE UNDER COVER LH
INSTALL RADIATOR SUPPORT OPENING COVER
1. Install the cover with the 6 clips.
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  
  Fig 7: Locating Radiator Support Opening Cover Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002