Throttle Body: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE ENGINE UNDER COVER LH
DRAIN ENGINE COOLANT (See COOLANT )
REMOVE RADIATOR SUPPORT OPENING COVER
1. Remove the 6 clips and radiator support opening cover.
  
  Fig 1: Locating Radiator Support Opening Cover Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR CLEANER ASSEMBLY
1. Disconnect the MAF meter connector.
2. Disconnect the wire harness from the wire harness clamp.
3. Loosen the hose clamp bolt, and then disconnect the No. 1 air cleaner inlet.
  
  Fig 2: Locating Hose Clamp Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 bolts.
5. Loosen the hose clamp bolt, and then remove the air cleaner.
  
  Fig 3: Locating Hose Clamp Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE THROTTLE BODY ASSEMBLY WITH MOTOR
1. Disconnect the ventilation hose.
2. Disconnect the No. 2 ventilation hose.
3. Disconnect the No. 1 fuel vapor feed hose.
  
  Fig 4: Locating No. 1 Fuel Vapor Feed Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disconnect the water by-pass hose.
5. Disconnect the No. 2 water by-pass hose.
  
  Fig 5: Locating No. 2 Water By-Pass Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Disconnect the throttle control motor connector.
7. Disconnect the throttle position sensor connector.
  
  Fig 6: Locating Throttle Position Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Remove the bolt, 2 nuts and throttle with motor body.
  
  Fig 7: Locating Motor Body Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. Remove the gasket from the intake manifold.
  
  Fig 8: Locating Intake Manifold Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002