LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Brake Control/Dynamic Control System) >> Anti-Lock Brake System >> Problem Symptoms Table
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Problem Symptoms Table

WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

If there are no DTCs output and the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

NOTE: When replacing the brake actuator assembly, sensors, etc., turn the ignition switch off.

HINT:

Anti-lock Brake System 

ANTI-LOCK BRAKE SYSTEM REFERENCE CHART

Symptom Suspected Area See
ABS and/or EBD does not operate Check for DTCs again and make sure that the normal system code is output. DTC CHECK / CLEAR 
IG power source circuit DTC C1241/41 LOW BATTERY POSITIVE VOLTAGE OR ABNORMALLY HIGH BATTERY POSITIVE VOLTAGE 
Front speed sensor circuit DTC C0200/31 FRONT SPEED SENSOR RH CIRCUIT; DTC C0205/32 FRONT SPEED SENSOR LH CIRCUIT; DTC C1271/71 LOW OUTPUT SIGNAL OF FRONT SPEED SENSOR RH (TEST MODE DTC); DTC C1272/72 LOW OUTPUT SIGNAL OF FRONT SPEED SENSOR LH (TEST MODE DTC) 
Rear speed sensor circuit DTC C0210/33 REAR SPEED SENSOR RH CIRCUIT; DTC C0215/34 REAR SPEED SENSOR LH CIRCUIT; DTC C1273/73 LOW OUTPUT SIGNAL OF REAR SPEED SENSOR RH (TEST MODE DTC); DTC C1274/74 LOW OUTPUT SIGNAL OF REAR SPEED SENSOR LH (TEST MODE DTC) 
Check the brake actuator assembly using the Techstream. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. ON-VEHICLE INSPECTION 
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). REMOVAL 
ABS and/or EBD does not operate efficiently Check for DTCs again and make sure that the normal system code is output. DTC CHECK / CLEAR 
Front speed sensor circuit DTC C0200/31 FRONT SPEED SENSOR RH CIRCUIT; DTC C0205/32 FRONT SPEED SENSOR LH CIRCUIT; DTC C1271/71 LOW OUTPUT SIGNAL OF FRONT SPEED SENSOR RH (TEST MODE DTC); DTC C1272/72 LOW OUTPUT SIGNAL OF FRONT SPEED SENSOR LH (TEST MODE DTC) 
Rear speed sensor circuit DTC C0210/33 REAR SPEED SENSOR RH CIRCUIT; DTC C0215/34 REAR SPEED SENSOR LH CIRCUIT; DTC C1273/73 LOW OUTPUT SIGNAL OF REAR SPEED SENSOR RH (TEST MODE DTC); DTC C1274/74 LOW OUTPUT SIGNAL OF REAR SPEED SENSOR LH (TEST MODE DTC) 
Stop light switch circuit DTC C1249/49 OPEN IN STOP LIGHT SWITCH CIRCUIT 
Check the brake actuator assembly using the Techstream. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. ON-VEHICLE INSPECTION 
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). REMOVAL 
ABS sensor DTC check cannot be done Check for DTCs again and make sure that the normal system code is output. DTC CHECK / CLEAR 
TC and CG terminal circuit TC AND CG TERMINAL CIRCUIT 
If the symptoms still occur even after the above circuit in suspected areas has been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). REMOVAL 
ABS warning light abnormal (Remains on) ABS warning light circuit ABS WARNING LIGHT REMAINS ON 
Brake actuator assembly (Skid control ECU) REMOVAL 
ABS warning light abnormal (Does not come on) ABS warning light circuit ABS WARNING LIGHT DOES NOT COME ON 
Brake actuator assembly (Skid control ECU) REMOVAL 
Brake warning light abnormal (Remains on) Brake warning light circuit BRAKE WARNING LIGHT REMAINS ON 
Brake actuator assembly (Skid control ECU) REMOVAL 
Brake warning light abnormal (Does not come on) Brake warning light circuit BRAKE WARNING LIGHT DOES NOT COME ON 
Brake actuator assembly (Skid control ECU) REMOVAL 
Sensor check cannot be done TS and CG terminal circuit TS AND CG TERMINAL CIRCUIT 
Brake actuator assembly (Skid control ECU) REMOVAL