LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2010 >> Land Cruiser >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (Service Information) >> Power Steering Oil Pressure Switch >> Removal >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Steering Oil Pressure Switch: Removal: Removal

  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH  . Refer to REMOVAL - Step 1
  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH  . Refer to REMOVAL - Step 2
  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 17
  4. REMOVE AIR CLEANER HOSE ASSEMBLY  . Refer to REMOVAL - Step 8
  5. REMOVE AIR CLEANER ASSEMBLY  . Refer to REMOVAL - Step 24
  6. REMOVE V-BANK COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 22
  7. REMOVE FAN & GENERATOR V BELT  . Refer to REMOVAL - Step 5
  8. DRAIN POWER STEERING FLUID 
  9. REMOVE FRONT WHEEL 
  10. REMOVE FRONT FENDER APRON SEAL FRONT RH  . Refer to REMOVAL - Step 5
  11. REMOVE POWER STEERING OIL PRESSURE SWITCH 
    1. Disconnect the switch connector.
      Fig 1: Locating Power Steering Oil Pressure Switch Connector
      GTY142415Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 24 mm deep socket wrench, remove the oil pressure switch.
    3. Remove the O-ring.
scientia non olet · About LEMON Manuals