Transaxle Assembly: Remove, Install, and Overhaul
WARNING: This page is about the Matrix Base, Automatic, which is a different variant/trim than selected.
Includes: Inspect and replace all necessary Transmission and Differential components and road test.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 1.8L Eng | Includes: R&I Subframe. DOES NOT include wheel alignment. Includes: Bleed Clutch System. Includes: R&I Engine and Transmission Assembly. | 18.5 | 10.5 | A |
| Combination Procedure: CLUTCH PRESSURE PLATE: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: CLUTCH RELEASE BEARING: Remove & Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| Rear | 0.7 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.5 | C | |||