Power Steering Oil Pressure Switch: Installation: Installation

INSTALL POWER STEERING OIL PRESSURE SWITCH
1. Install a new O-ring to the oil pressure switch.
2. Apply a light coat of engine oil to the O-ring of the oil pressure switch.
3. Using a 24 mm deep socket wrench, install the oil pressure switch.
  Torque: 21 N*m (210 kgf*cm, 15 ft.*lbf)
  NOTE:
  - Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (surface which contacts the pressure feed tube).
  - Be careful not to damage the O-ring when installing the power steering oil pressure switch
4. Connect the oil pressure switch connector.
ADD POWER STEERING FLUID
INSPECT FOR POWER STEERING FLUID LEAK
BLEED POWER STEERING FLUID . Refer to ON-VEHICLE INSPECTION - Step 2