Steering Angle Sensor: Removal: Removal
NOTE:
- Do not remove the steering angle sensor from the spiral cable.
- While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or open/ close the doors while the battery is connected.
- PRECAUTION WARNING:
Be sure to read Precaution thoroughly before servicing. Refer to PRECAUTION .
- ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
- REMOVE STEERING PAD
HINT:
Refer to the procedure up to Remove Steering Pad. Refer to REMOVAL .
- REMOVE STEERING WHEEL ASSEMBLY . Refer to REMOVAL - Step 3
- REMOVE LOWER STEERING COLUMN COVER . Refer to REMOVAL - Step 6
- REMOVE UPPER STEERING COLUMN COVER . Refer to REMOVAL - Step 7
- REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR
- Remove the spiral cable with steering angle sensor. Refer to REMOVAL - Step 4
.NOTE:
- Do not replace spiral cable with steering angle sensor with the battery connected and the power switch on (IG).
- Do not rotate the spiral cable with steering angle sensor with the battery connected and the power switch on (IG).
- Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
- Do not remove the steering angle sensor from the spiral cable.
- Remove the spiral cable with steering angle sensor. Refer to REMOVAL - Step 4
.