DTC Check / Clear

WARNING: This page is about a different variant/trim than selected.

CHECK FOR DTCS (PLUG-IN CONTROL)
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Plug-in Control / Trouble Codes.
4. Check the DTCs and freeze frame data, and write them down.
5. Check the details of the DTCs. Refer to DIAGNOSTIC TROUBLE CODE CHART .
CHECK FREEZE FRAME DATA AND INFORMATION
1. If a DTC is present, select it in order to display its freeze frame data.
2. Read the freeze frame data recorded when the DTC was set.
  NOTE:
  When checking the information codes for the plug-in charge control system, refer to Detail Code 1 to 5.
CHECK FOR DTCS (SYSTEMS OTHER THAN PLUG-IN CONTROL)
HINT:

The plugin charge control ECU assembly maintains communication with other computers, including the power management control ECU, ECM and skid control ECU. Therefore, if the plugin charge control ECU assembly outputs a warning, it is necessary to check and record the DTCs of all systems.
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Health Check.
4. If DTCs are present, check the relevant systems.
  HINT:
  
  If DTCs for the CAN communication system are present in addition to other DTCs, first troubleshoot and repair any malfunctions in the CAN communication system. Refer to HOW TO PROCEED WITH TROUBLESHOOTING .
CLEAR DTCS
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Plug-in Control / Trouble Codes.
4. Clear DTCs and freeze frame data.
  NOTE:
  Clearing the DTCs will also clear the freeze frame data. Refer to FREEZE FRAME DATA .