How To Proceed With Troubleshooting [06/2016 - ]: Procedure

Result

Result: 

NEXT 

See step  2

• In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

• Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

• The following 5 items are important points in the problem analysis:

Result

Result: 

NEXT 

See step  3

1. Measure the battery voltage.

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

2. Check the fuses and relays.
3. Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Use the techstream to check if the LIN communication system is functioning normally.

   Refer to DTC CHECK / CLEAR [06/2016 - ]

   Result

   Result	Proceed to
   No DTCs output	A
   DTCs output	B

Result: 

B 

GO TO LIN COMMUNICATION SYSTEM. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2016 - 03/2017]  Refer to  DIAGNOSTIC TROUBLE CODE CHART [03/2017 - ] 

Result: 

A 

See step  5

1. Check for DTCs and note any codes that are output.

   Refer to DTC CHECK / CLEAR [06/2016 - ] 

2. Clear the DTCs.
3. Recheck for DTCs.

   Result

   Result	Proceed to
   No DTCs output	A
   DTCs output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2016 - ]  

Result: 

A 

See step  6

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [06/2016 - ] 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

See step  8

Result: 

A 

See step  7

1. Operation Check.

   Refer to OPERATION CHECK [06/2016 - ] 

2. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [06/2016 - ] 

3. Terminals of ECU.

   Refer to TERMINALS OF ECU [06/2016 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

See step  9

1. If the power window regulator master switch assembly or power window regulator switch assembly LED is blinking, reset the power window regulator motor assembly.

   Refer to INITIALIZATION [06/2016 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  10

Result

Result: 

NEXT 

END