Removal & Installation
WARNING: This page is about the Highlander LE, 2.7L Eng VIN A, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| In-Line4 | Includes:Drain and refill Low Temperature Cooling System. Includes: Programming. DOES NOT include wheel alignment. | 7.3 | C | |
| Combination Procedure: CONVERTER: Drain & Test: | ||||
| Gas | 0.2 | C | ||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| Gas, Rear | 0.4 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| Gas | 0.2 | C | ||
| Combination Procedure: INPUT SHAFT SEAL: Remove & Replace: | ||||
| 0.2 | B | |||
| Combination Procedure: OUTPUT SEAL: Remove & Replace: | ||||
| Each | 0.2 | B | ||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| In-Line4 | 0.1 | C | ||
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: | ||||
| Gas,FWD | Includes: Programming. Includes: R&I Transfer Case Assembly. | 0.8 | C | |
| Combination Procedure: TRANSMISSION OIL COOLER: Clean: | ||||
| 0.5 | C | |||