General Maintenance [08/2015 - ]: Procedure

1. Remove the air conditioning filter (Refer to PROCEDURE - Step 3 [08/2015 - ] ).
   NOTE:

   Before removing the air conditioning filter, turn the engine switch off and set the air conditioner to recirculation mode.

2. Visually inspect the surface of the air conditioning filter.
3. If the air conditioning filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.
   NOTE:

   Some filters are not able to be cleaned.

1. Tighten the bolts and nuts on the chassis parts listed below, if necessary.
   • Front axle and suspension
   • Drivetrain
   • Rear axle and suspension
   • Brake system
   • Engine mounting
   • Other chassis parts
2. Tighten the bolts and nuts on the body parts listed below, if necessary.
   • Seat belt system
   • Seats
   • Doors and hood
   • Body mountings
   • Fuel tank
   • Exhaust pipe system
   • Other body parts

1. Check the operation of these vehicle body parts.
   1. Hood
      • Auxiliary catch operates properly.
      • Hood locks securely when closed.
   2. Front and rear doors
      • Door locks operate properly.
      • Doors close properly.
   3. Back door
      • Doors close properly.
   4. Seats
      • Seat adjusts easily and locks securely in any position.
      • Front seatback locks securely in any position.
   5. Be sure that the vehicle is clean before returning it to the customer. In particular, pay attention to the following:
      • Steering wheel
      • Shift lever knob
      • All switch knobs
      • Seats

Refer to PROCEDURE - Step 1 [08/2015 - ]