Installation [11/2020 - ]: Procedure
- INSTALL REAR SPEED SENSOR LH NOTE:
- The rear speed sensor is easily damaged. When installing the rear speed sensor to the rear axle hub LH, do not use excessive force to rotate and install it.
- Prevent foreign matter from attaching to the sensor tip.
- Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.
- Remove any dirt or foreign matter on and around the connector before performing this step.
- Do not allow water, oil or dirt to enter the connector.
Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf)
- INSTALL REAR WHEEL
Refer to INSTALLATION [11/2020 - ]
- CHECK FOR SPEED SENSOR SIGNAL
Refer to TEST MODE PROCEDURE [11/2020 - ]