Installation [11/2015 - 12/2018]: Procedure

INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
1. Install the rear axle hub and bearing assembly.
  Refer to PROCEDURE - Step 1
  
  HINT:
  - The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.
  - If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
INSPECT REAR AXLE HUB BEARING LOOSENESS
Refer to PROCEDURE - Step 9
INSPECT REAR AXLE HUB RUNOUT
Refer to PROCEDURE - Step 10
INSTALL REAR DISC
Refer to PROCEDURE - Step 1 [11/2015 - 11/2017] , or refer to PROCEDURE - Step 1 [11/2017 - 12/2018]
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Refer to PROCEDURE - Step 12
CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Refer to PROCEDURE - Step 11 [11/2015 - 11/2017] , or refer to PROCEDURE - Step 11 [11/2017 - 12/2018]
INSTALL PARKING BRAKE LEVER PROTECTOR
Refer to PROCEDURE - Step 2 [11/2015 - 11/2017] , or refer to PROCEDURE - Step 2 [11/2017 - ]
CONNECT SKID CONTROL SENSOR WIRE
1. Connect the skid control sensor wire connector to the rear axle hub and bearing assembly.
ADJUST PARKING BRAKE
Refer to ADJUSTMENT [11/2015 - 11/2017] , or refer to ADJUSTMENT [11/2017 - ]
INSTALL REAR WHEEL
Refer to PROCEDURE - Step 1
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
1. Connect the cable to the negative (-) auxiliary battery terminal.
  Refer to PROCEDURE - Step 2
2. Connect the reservoir level switch connector.
3. Turn the power switch on (READY).
4. Depress the brake pedal and release it.
5. Clear the DTCs.
  Refer to DTC CHECK / CLEAR [11/2015 - 12/2018]
CHECK FOR SPEED SENSOR SIGNAL
Refer to TEST MODE PROCEDURE [11/2015 - 12/2018]