Utility [09/2016 - ]

HINT: 

• With "All Readiness", you can check whether or not the DTC judgment has been completed by using the Techstream.
• You should check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs.

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs even if no DTCs are stored.

   Powertrain > Plug-in Control > Clear DTCs 

5. Turn the power switch off and wait for 2 minutes or more.
6. Turn the power switch on (IG).
7. Perform the DTC judgment driving pattern to run the DTC judgment.
8. Enter the following menus: Powertrain / Plug-in Control / Utility / All Readiness.

   Powertrain > Plug-in Control > Utility 

   Tester Display
   All Readiness

9. Input the DTCs to be confirmed.
10. Check the DTC judgment result.

    Techstream Display	Description
    Normal	DTC judgment completed System normal
    Abnormal	DTC judgment completed System abnormal
    Incomplete	DTC judgment not completed Perform the driving pattern
    N/A	Unable to perform DTC judgment Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit Perform the driving pattern

    If the judgment result shows Incomplete or N/A, perform the DTC confirmation driving pattern again.

11. Turn the power switch off.

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Plug-in Control / Utility / Vehicle Control History (RoB).

   Powertrain > Plug-in Control > Utility 

   Tester Display
   Vehicle Control History (RoB)

   Refer to VEHICLE CONTROL HISTORY [09/2016 - ]

5. Turn the power switch off.