How To Proceed With Troubleshooting [08/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Check for DTCs and make a note of any codes that are output.
2. Clear the DTCs.
3. Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the same DTC by simulating the symptoms indicated by the DTC.

   Result

   Result	Proceed to
   No DTCs output	A
   DTCs output	B
   CAN communication system DTCs are output	C
   LIN communication system DTCs are output	D

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2019]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2019 - ]  

Result: 

C 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2017]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2017 - 08/2019]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ] 

Result: 

D 

GO TO LIN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] 

Result: 

A 

See step  4

1. Refer to the Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2017] , or refer to PROBLEM SYMPTOMS TABLE [08/2017 - 08/2019] , or refer to PROBLEM SYMPTOMS TABLE [08/2019 - ] 

   Result

   Result	Proceed to
   Fault not listed in Problem Symptoms Table	A
   Fault listed in Problem Symptoms Table	B

Result: 

B 

See step  6

Result: 

A 

See step  5

1. Operation Check.

   Refer to OPERATION CHECK [08/2015 - 08/2019] , or refer to OPERATION CHECK [08/2019 - ] 

2. Terminals of ECU.

   Refer to TERMINALS OF ECU [08/2015 - 08/2017] , or refer to TERMINALS OF ECU [08/2017 - 08/2019] , or refer to TERMINALS OF ECU [08/2019 - ] 

3. Data List/Active Test.

   Refer to DATA LIST / ACTIVE TEST [08/2015 - 08/2019] , or refer to DATA LIST / ACTIVE TEST [08/2019 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  6

Result

Result: 

B 

See step  8

Result: 

A 

See step  7

1. If the power window regulator master switch AUTO light is blinking, reset the power window regulator motor.

   Refer to INITIALIZATION [08/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END