Installation [12/2022 - ]: Procedure
- INSTALL NO. 1 ECM BRACKET
Torque: 4.5 N*m (46 kgf*cm, 40 in.*lbf)
- INSTALL NO. 2 ECM BRACKET
Torque: 4.5 N*m (46 kgf*cm, 40 in.*lbf)
- INSTALL ECM
- Install the ECM to the engine mounting insulator LH with the 2 nuts.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
NOTE:If the ECM has been struck or dropped, replace it.
- Engage the 2 clamps.
- Connect the 2 ECM connectors and lower the 2 lock levers.NOTE:
- When connecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
- Be sure to securely connect the ECM connectors.
- Install the ECM to the engine mounting insulator LH with the 2 nuts.
- CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 5
- INSTALL BATTERY SERVICE HOLE COVER ASSEMBLY
Refer to PROCEDURE - Step 6 - VEHICLE IDENTIFICATION NUMBER (VIN) REGISTRATION
Refer to PROCEDURE - Step 1
- ECU CONFIGURATION
Refer to ECU CONFIGURATION [12/2022 - ]
- UPDATE ECU SECURITY KEY
Refer to UPDATE ECU SECURITY KEY [12/2022 - ]
- INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Refer to AUTOMATIC LEARNING CHART [12/2022 - 03/2023] , or refer to AUTOMATIC LEARNING CHART [03/2023 - ]