Installation [02/2024 - ]: Procedure
- INSTALL ECM BRACKET
Torque: 4.5 N.m (46 kgf/cm, 40 in.lbf)
- INSTALL NO. 2 ECM BRACKET
Torque: 4.5 N.m (46 kgf/cm, 40 in.lbf)
- INSTALL ECM
Install in this Direction - - - Install the ECM with the 4 bolts and 2 clamps.
Torque: 13 N.m (133 kgf/cm, 10 ft.lbf)
NOTE:If the ECM has been struck or dropped, replace it.
- Connect the 2 ECM connectors and rotate the 2 levers to lock them.NOTE:
- When connecting the ECM connectors, make sure that the connecting parts of the ECM connectors are free of dirt, water and other foreign matter.
- Be sure to securely connect the ECM connectors.
- Install the ECM with the 4 bolts and 2 clamps.
- INSTALL TCM
Refer to PROCEDURE - Step 2 - CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 5
- PERFORM VEHICLE IDENTIFICATION NUMBER (VIN) REGISTRATION
Refer to REGISTRATION [02/2024 - ]
- ECU CONFIGURATION
Refer to ECU CONFIGURATION [02/2024 - ]
- UPDATE ECU SECURITY KEY
Refer to UPDATE ECU SECURITY KEY [02/2024 - ]
- PERFORM INITIALIZATION
Refer to WORK PROCEDURE [02/2024 - ]
- INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Refer to AUTOMATIC LEARNING CHART [02/2024 - ]