On-Vehicle Inspection [12/2024 - ]: Procedure

Pre-procedure1

• Check the terminal voltage.
  1. Disconnect the No. 2 turbo pressure sensor connector.

• Measure the voltage according to the value(s) in the table below.

  Standard Voltage

  Tester Connection	Condition	Specified Condition	Result
  A12-3(VC) - A12-1(E2)	Ignition switch ON	4.5 to 5.5 V	V

  If the result is not as specified, repair or replace the wire harness or connector.

• Check the turbo pressure.
  1. Turn the ignition switch to ON.
  2. According to the display on the GTS read the Data List.

     Powertrain > Engine > Data List 

     Tester Display
     Boost Pressure Sensor

     OK

     The value is approximately equal to atmospheric pressure.

     HINT: 

     • Standard atmospheric pressure is approximately 101 kPa (abs) (15 psi (abs)).
     • For every 100 m (328 ft.) increase in altitude, atmospheric pressure drops by approximately 1 kPa (0.15 psi). This varies by weather.

Post-procedure1

• None