Hydraulic System Bleeding

Remove filler cap from master cylinder reservoir and fill with hydraulic fluid. Attach a rubber hose to slave cylinder bleeder screw, and insert opposite end of hose into a container partially filled with hydraulic fluid.

Loosen bleeder screw approximately one-half turn. Push clutch pedal to bottom of stroke and allow to return unassisted. Continue operation until fluid being discharged into container is free of air bubbles. Tighten bleeder screw on down stroke of pedal. Check fluid level in reservoir and refill as necessary.

TIGHTENING SPECIFICATIONS

Application		Ft. Lbs. (mkg)
Clutch-to-Flywheel
	Spitfire	16-22 (2.2-3.0)
	TR6 & TR7	16-20 (2.2-2.7)
Clutch Housing-to-Engine
	Spitfire	10-14 (1.4-1.9)
	TR6 & TR7	15-20 (2.0-2.7)
Transmission-to-Clutch Housing
	TR6 & TR7	24-32 (3.3-4.4)
Slave Cylinder-to-Clutch Housing
	TR7	16-21 (2.2-2.9)