Rear Side Door Window Removal And Installation/Replacement

Mobile Repair Possible: Van/Car

Removal Procedure:

The procedure for the left-hand component is identical to that for the right-hand side.

Remove rear side water deflector. Refer to REAR SIDE DOOR WATER DEFLECTOR REMOVAL AND INSTALLATION/REPLACEMENT
Remove rear side door window inner sealing strip. Refer to REAR SIDE DOOR WINDOW INNER SEALING STRIP REPLACEMENT
Remove rear side door C-pillar trim. Refer to REAR SIDE DOOR C-PILLAR TRIM REMOVAL AND INSTALLATION/REPLACEMENT
WARNING:
Crushing by moving parts
Failure to follow specified procedures may result in death or serious injury due to movement of the window regulator.
- Secure the component against uncontrolled movement.
- Always use personal protective equipment (PPE)
- Ensure vehicle is correctly disabled/powered down to prevent unexpected motion or activation of components.
Position the rear side door window regulator (1) in a way that the bolts of the door window is accessible through the opening.
Secure the door window pane against falling down.
Remove 2 bolts (1).
Torque: 8 Nm

Courtesy of VINFAST, LLC
Angle the rear side door window (1) outward and remove it from the door by lifting it upward.
NOTE:
Risk of damage when removing components
Failure to follow specified procedures may result in damage to body work or vehicle paint work.
- Body sheets remaining on the vehicle must not be damaged or deformed.
- Painted surfaces must be masked off/protected appropriately.

Installation Procedure:

Installation is the reverse of removal procedure, noting the following. All fasteners must be tightened to torque specification!
Install rear side door C-pillar trim. Refer to REAR SIDE DOOR C-PILLAR TRIM REMOVAL AND INSTALLATION/REPLACEMENT
Install rear side door window inner sealing strip. Refer to REAR SIDE DOOR WINDOW INNER SEALING STRIP REPLACEMENT
Install rear side water deflector. Refer to REAR SIDE DOOR WATER DEFLECTOR REMOVAL AND INSTALLATION/REPLACEMENT