Engine Controls
- Disconnect cold start device. Disconnect link rod at lever on injection pump. Adjust accelerator cable by turning sheath until cable is stretched, but does not influence pulley position. Pulley should touch idle stop.
- Depress accelerator pedal fully. Pulley should touch full speed stop. Adjust kickdown cable on automatic transmission models. Depress accelerator pedal to floor. Kickdown cable should move approximately 2.05" (52 mm) between end positions.
- In idle position, kickdown cable should be stretched and distance between kickdown cable clip and cable sheath should be .01-.04" (.25-1.0 mm).
- Connect link rod to injection pump lever. Adjust link rod in maximum position by turning pulley to maximum position. Adjust link rod length so injection pump lever touches maximum speed adjusting screw.
- Adjust link rod in idle position by returning pulley to idle stop. Move link rod ball joint in oblong hole in injection pump lever until lever touches idle adjusting screw.
- Readjust link rod by repeating steps 4) and 5). A clearance of .012" (.3 mm) is permitted between pulley and maximum speed stop. Connect cold start device.