Fuel Pump Circuit
- With fuel injection system relay removed, check for battery voltage at terminal No. 30. See Figure . If battery voltage is not present, repair wiring between relay connector and battery.
- Connect jumper wire between terminals No. 30 and 87/2 of fuel injection system relay connector. Fuel pumps should run. If not, check wiring between pump and relay. Also check wiring between terminals No. 87/1 and 85 for continuity. Repair as necessary.
NOTE:
ECU terminal identifications are marked on the unit or connector.
CAUTION:
Ignition must be off when connecting or disconnecting ECU connector.