Ground Circuit Checks
- Turn ignition switch to OFF position. On all models except 740 GL with Bendix Rex 1 ignition and 740 GLE, connect an ohmmeter between ground and ECU connector pins No. 20 and No. 14.
- On 740 GL with Bendix RX7 1 ignition and 740 GLE models, connect ohmmeter between ground and ECU connector pin No. 20. On all models, ohmmeter should read continuity.
- Turn ignition switch to OFF position. Connect voltmeter leads between ECU connector pins No. 6 (Blue wire) and No. 20 (Brown wire). See Figure .
- Turn ignition switch to ON. Voltmeter should read 12 volts (battery voltage. If no voltage exists, check pin No. 20 wire for bad ground.