Idle Air Control Valve
- Turn ignition switch to OFF position. Disconnect ECU connector. Fuel injection ECU is located on right side of instrument panel, under kick panel. Push out clip and disconnect ECU connector.
- Remove cover from ECU connector to expose pin identification numbers. Visually inspect all pin connector sleeves to ensure all pins are at same height.
- On 240, 240 DL, 740 GL and 740 GLE, connect an ohmmeter between fuel ECU connector pins No. 9 and No. 33. Ohmmeter should read 8 ohms.
- On 740 Turbo, 760 Turbo and 760 GLE, connect ohmmeter between fuel ECU connector pins No. 9 and No. 10, and then between pins No. 9 and No. 23. Ohmmeter should read 20 ohms in each reading.