Detonation (Knock) Sensors (960)
- Turn ignition off and remove fuse No. 24. Connect Measuring Unit (999 3070) between ECU and ECU connector. See Figure
. Turn ignition on.
- Depending upon which knock sensor is being checked, disconnect front or rear knock sensor connector and connect a jumper wire between knock sensor connector terminals.
- Connect an ohmmeter between measuring unit terminals No. 2 and terminal No. 11 or 29 (depending on which sensor is being checked). Reading should be zero ohms. If reading is correct, replace knock sensor. Tighten knock sensor to 15 ft. lbs. (20 N.m).
Courtesy of VOLVO CARS OF NORTH AMERICA.