Signal missing: Verification
HINT: After rectifying a fault, a verification should be carried out.
- Reinstall the connectors, components etc.
- Ignition on.NOTE:
For certain faults in the CAN-net where control modules have stopped communicating, it may help to disconnect/reconnect the battery o "restart" the control module/CAN-net.
- Erase diagnostic trouble codes (DTCs) in all control modules.
- Ignition off.
- Ignition on.
- Start the vehicle. Allow the vehicle to run for 10 minutes.
- Read out the diagnostic trouble codes in the vehicle via the DIAGNOSTICS tab.
Does the diagnostic trouble code (DTC) for faulty communication return?
- YES
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
- NO
OKAY: Troubleshooting has been completed.