LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volvo >> 2000 >> S80 Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Ignition And Control Systems - Specifications, Electrical/Electronic >> Specifications, Engine Management System (B5254T2; 2004) >> Component specifications
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component specifications

The component specification gives the value of the component when the connector is disconnected. Where no value is given, it is not possible to measure a relevant value at the component.

The graphic within the brackets indicates the terminal pin on the component to which the value refers.

Designation  Type  Supply voltage  Value  Other 
Air conditioning (A/C) relay Mechanical relay 12 V (#1) Approximately 96 Ω (coil) -
A/C pressure sensor Manifold absolute pressure (MAP) sensor 5 V (#3) - -
Stop lamp switch Position switch 12 V (#1) The switch is closed when the pedal is depressed (terminals #1-#5) -
Fuel pump (FP) relay Mechanical relay - Approximately 96 Ω (coil) The relay is controlled by the central electronic module (CEM)
Engine cooling fan (FC) control module - - - There are different engine cooling fan control modules depending on the engine variant.
Canister purge (CP) valve Electromagnetic valve 12 V (#1) 17-24 Ω at 20°C (terminals #1-#2) -
Accelerator pedal (AP) position sensor Electronic pedal sensor with 2 output signals, PWM and a linear analog signal 12 V (terminal #1) 5 V (terminal #6) Power supply analog position sensors - -
Throttle unit Electronic throttle control module with two integrated potentiometers and a damper motor 5 V (#3) 1.2-3.5 Ω (terminals #1-#4 motor winding).
1000-1500 Ω (terminals #2-#3 Parallel connection of potentiometers 1 and 2).
Approximately 820 Ω when the throttle is closed. Approximately 1580 Ω at wide open throttle (terminals #2-#6 potentiometer 1).
Approximately 1480 Ω when the throttle is closed. Approximately 500 Ω at wide open throttle (terminals #2-#5 potentiometer 2)
-
Injector Electromagnetic injector valve 12 V (#1) Approximately 12 Ω at 20°C (terminal #1-#2) -
Camshaft sensor Magneto-resistive sensor 5 V (#1) - -
Knock sensor (KS) Piezo electric component - Greater than 1 MΩ (terminal #1-#2 front knock sensor (KS)).
Greater than 1MΩ (terminals #3-#4 rear knock sensor (KS))
Separate signal ground for the knock sensors (KS)
Clutch pedal sensor Slide potentiometer 5 V (#2) Unaffected pedal: 1400-2400 Ω
Fully depressed pedal: 200-800 Ω (#2-#4)
-
Engine cooling fan (FC) control modules Fan motor 12 V (#1) - The engine cooling fan (FC) is controlled by the engine control module (ECM)
Coolant level sensor Position switch Connected to ground (terminal #2) Closed when the engine coolant level is normal -
Boost pressure sensor Manifold absolute pressure (MAP) sensor 5 V (#3) - Turbocharged (TC) engines only
Preheating front heated oxygen sensor (HO2S) PTC resistor 12 V (#3) 2.6-3.4 Ω at 20°C (terminals #3-#4) -
Preheating, rear heated oxygen sensor (HO2S) PTC resistor 12 V (#1) Approximately 9 Ω at 20°C (terminal #1-#2) -
Mass air flow (MAF) sensor - 12 V (#2)
5 V (#4)
- -
Intake air temperature (IAT) sensor inlet NTC resistor Turbocharged engines: 5 V (#2)
Naturally aspirated engines: 5 V (#1)
5886 Ω at 0°C
3791 Ω at 10°C
2510 Ω at 20°C
1715 Ω 30°C
Turbocharged engines: (#1-#2).
Naturally aspirated engines: (#1-#3)
Turbocharged engines: intake air temperature (IAT) sensor, integrated in the boost pressure sensor.
Naturally aspirated engines: intake air temperature (IAT) sensor, integrated in the mass air flow (MAF) sensor
Leak diagnostic unit Consists of an air pump, electromagnetic valve and an internal heating element (PTC resistor) 12 V (#4) Approximately 118 Ω (terminals #1-#4 pump motor winding)
27.9 -34.1 Ω (terminals #3-#4 Valve coil)
The heating element for heating up the pulsed secondary air injection system (PAIR) pump is controlled by the central electronic module (CEM)
Engine coolant temperature (ECT) sensor NTC resistor 5 V (#1) 15040 Ω at -20°C
2450 Ω at 20°C
318 Ω at 80°C
(#1- #2)
-
PTC resistor air preheating PTC resistor 12 V (#1) Approximately 10 Ω at 20°C
(#1-#2)
-
Oil pressure sensor Pressure switch (Pressostat) Grounded in the cylinder block Closed switch when the oil pressure is low -
Camshaft reset valve Electromagnetic valve 12 V (#1) 3.7-11.1 Ω (#1-#2) -
Flywheel sensor Engine speed sensor - 108.5-142.5 Ω at 20°C (terminals #1-#2) -
System relay Mechanical relay 12 V (#1) Approximately 80 Ω (coil) -
Turbocharger (TC) control valve Electromagnetic valve (3 way) 12 V (#1) 21.8-24.2 Ω at 20°C (terminals #1-#2) Turbocharged (TC) engines only
Outer temperature sensor NTC resistor 5 V (#2) 18702 Ω at -20°C
6318 Ω at 0°C
2424 Ω at 20°C
1034 Ω at 40°C
(#2- #3)
-