Transmission Sensors - Removal And Installation

• Transmission
  • Temperature sensor, transmission fluid, replacing
    • Side cover, transmission, removing
    • Removing the temperature sensor
    • Installing the temperature sensor
    • Installing the side cover on the transmission
  • Transmission input speed sensor, replacing
    • Removing the line pressure solenoid
    • Removing the input speed sensor
    • Installing the input speed sensor
    • Installing the line pressure solenoid
  • Transmission output speed sensor, replacing (AW50-42)
    • Removal
      • Preparations
      • Remove the engine compartment components
      • Remove the screw holding the bracket to the heated oxygen sensors (HO2S)
      • Remove the sensor
    • Installation
      • Install the sensor
      • Connect the connector and secure it to the holder
      • Finishing work
  • Transmission output speed sensor, replacing (AW55-50)
    • Notes
    • Preparations
    • Removing the air cleaner (ACL) housing and intake manifold
    • Disassembling the connector for the transmission output speed sensor. Removing the sensor
    • Lubricating the O ring for the new transmission output speed sensor. Installing the sensor
    • Installing the air cleaner (ACL) housing and intake manifold
    • Checking diagnostic trouble codes (DTCs)
  • Transmission, installation
    • Notes
    • Cleaning and lubricating the input shaft
    • Checking before installing
    • Adjusting the position of the transmission and engine
    • Installing and tightening screws for the transmission
    • Lifting the engine and transmission to the horizontal position
    • Installing the rear engine mounting
    • Installing the bevel gear
    • Installing the front propeller shaft (Applies to AWD)
    • Installation of the collision protection above the steering gear (Only applies to right-hand drive vehicles.)
    • Fitting the sub-frame to the body
    • Installing the sealing ring for the CV joint housing
    • Installing the left hand drive shaft to the transmission, wheel spindle and link arm
    • Installing new lock nuts and screws on the steering gear
    • Installing the screw in the rear engine pad
    • Installing screws for the bracket for the heated oxygen sensor (HO2S) wiring
    • Installing the crossmembers
    • Installing the right-hand drive shaft to the gearbox, wheel spindle and link arm
    • Installing the screw for the front engine pad and the torque rod mounting in the transmission
    • Installing and tightening front suspension components
    • Tightening the ball joint pinion
    • Installing the nuts on the fender liner
    • Checking the oil level in the transmission
    • Installing the screws for the transmission and engine
    • Installing the pipe junction
    • Installing the bracket and lever for the transmission
    • Installing the water hose
    • Installing the upper torque rod
    • Transmission oil level, checking