Section 209 (Transmission - Installation)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission
- Transaxle, Installing
- Notes
- Installing the Transmission
- Adjusting the Position Of the Engine And Gearbox
- Installing And Tightening Screws For the Transmission
- Fitting the Torque Converter Screws.
- Lifting the engine/gearbox
- Installing the Rear Engine Mounting
- Installing the Bevel Gear
- Installing the Bracket
- Installing the Lower Charge Air Pipe
- Installing Oil Pipes To the Transmission
- Installing the Left Drive Shaft On the Transmission And the Wheel Spindle
- Fitting the Sub-Frame To the Body
- Installing the Right-Hand Drive Shaft To the Gearbox, Wheel Spindle And Link Arm
- Tightening the sub-frame screws (both sides)
- Installing the Screws For Engine Pads And the Torque Rod Bracket In the Transmission
- Installing the steering wheel shaft joint
- Installing the collision protection system over the steering gear
- Installing the crossmembers
- Installing and tightening front suspension components
- Installing the cable conduit
- Removing the lifting beam
- Installing the water hose
- Installing Screws For The Transmission/Starter Motor
- Installing Gear Selector Cable
- Installing Engine Compartment Components
- Finishing
- Tightening Torque
- Transaxle, Installing