Confirmation Of Component Activation (MODE 2)
This function provides confirmation that certain of the system components are operating. The test consists of activating one component after the other. The control module gives a confirmation in the form of a code if it positively identifies the component as activated. In this way both the component operational status and circuit integrity checks (open-circuits and short-circuits) can be carried out at the same time.
The following components are tested:
- ON/OFF switch
- brake pedal valve
- clutch pedal valve
- RESUME switch
- SET+ switch
- SET- switch
- brake light switch
- Park/neutral position (PNP) switch (automatic transmission).