Transmission - Inspection, Removal & Installation
- Transmission Cable
- Transmisson Check
- Transmission Fluid
- Transmission Installation
- Transmission, installing
- Notes
- Checking before installing
- Adjusting the position of the engine and transmission
- Installing and tightening the screws for the transmission
- Installing the dip stick pipe and oil hose on the oil cooler. Install the 3 screws for the transmission
- Installing the torque converter screws
- Installing components on the sub-frame
- Lifting the engine and transmission to the horizontal position
- Installing the rear engine mounting
- Installing the sub-frame on the bodywork
- Installing the left drive shaft on the transmission, wheel spindle and control arm
- Installing the engine stabilizer brace
- Installing the exhaust pipe on the turbocharger (TC) and the starter motor on the engine
- Installing the right drive shaft on the transmission, wheel spindle and control arm
- Installing and tightening the sub-frame screws
- Installing and tightening front end components (both sides)
- Tightening the ball joint pinion
- Installing a new screw and new lock nuts for the steering gear
- Removing the tie strap from the steering gear
- Installing and tightening the screw for the rear engine pad
- Installing the delivery line on the rubber hoses
- Installing the front cross member
- Installing the screw for the ground lead and cable conduit
- Lowering the car and removing the lifting beam and lifting tools from the engine
- Installing the remaining screws for the transmission and starter motor
- Installing the torque control arm
- Installing the transmission cable bracket on the transmission and the cable on the lever
- Installing the air hose on the turbocharger (TC) and the delivery line on the manifold
- Installing the upper torque rod in the engine compartment
- Installing the air cleaner (ACL) housing and engine cover
- Checking the transmission fluid level
- Transmission, installing