Input Speed Sensor, Clutch Pedal Position Sensor - Removal & Installation

• Transmission
  • Gearbox, removing
    • Notes
    • Preparatory work
      • Filling in diagnostic and check lists
    • Removal
      • Disconnect battery lead
      • Remove engine compartment components
      • Remove components from gearbox
      • Remove gearbox mounting screws
      • Remove coolant hose from passenger compartment heater
      • Install lifting beam and lifting hook on engine lifting eyelet
      • Remove air baffle and splash guard under engine
      • Remove screw for cable duct
      • Remove cross members from body
      • Remove screws and nuts for engine pads, torque rod
      • Measure position of tie rod in steering gear
      • Expose steering shaft joint
      • Remove front suspension components (both sides)
      • Preparations when removing gearbox
      • Preparations for lowering sub-frame
      • Remove right-hand drive shaft
      • Remove left-hand drive shaft
      • Lower sub-frame
      • Remove bevel gear
      • Remove rear engine mounting
      • Remove screws from torque converter
      • Remove oil pipe from gearbox
      • Lower engine and gearbox
      • Install fixture on mobile jack and gearbox
      • Remove all screws for gearbox and engine
      • Remove gearbox
  • Gearbox, installing
    • Notes
    • Installation
      • Notes
      • Install gearbox
      • Install and tighten screws to gearbox
      • Fit torque converter screws.
      • Lift engine/gearbox
      • Install rear engine mounting
      • Install angle gear
      • Install lower oil pipe to gearbox
      • Install left-hand drive shaft to gearbox and wheel spindle
      • Fit sub-frame to body
      • Install right-hand drive shaft to gearbox, wheel spindle and link arm
      • Tighten sub-frame screws (both sides)
      • Fit screws for engine pads and torque rod bracket in gearbox
      • Install steering wheel shaft joint
      • Install crossmembers
      • Install and tighten front suspension components
      • Install cable conduit
      • Remove lifting beam
      • Install water hose
      • Fit remaining screws to gearbox/starter motor
      • Install gear selector cables and oil line
      • Install service clips
      • Install engine compartment components
    • Finishing
      • Install battery cable
      • Check
  • Gearbox input speed sensor, replacing
    • Notes
    • Removing/installing
      • Removal
    • Installation
  • Input speed sensor/output speed sensor, replacing
    • Notes
    • Removal
      • Preparations
      • Remove air cleaner (ACL) housing
      • Remove cable harness
    • Installation
      • Notes
      • Install sensor
      • Install air cleaner (ACL) housing
  • Lubrication, transmission, specifications
    • Transmission, manual
    • Transmission, automatic
    • Other
    • Constant velocity joint boot, grease quantity
  • Oil level, transmission (AW55-50/51SN), checking
    • Preparatory work
      • Remove lower engine cover
      • Remove air filter housing
      • Before filling
      • Install air cleaner (ACL)
    • Check
      • Basic fluid level check
    • Finishing
      • Install filler plug
      • Install air cleaner (ACL)
      • Check oil level
      • Install lower engine cover
  • Oil level, transmission (AW50-42), checking
    • Notes
    • Check oil level
      • Conditions
      • Preparation to check oil level
      • Move gear selector through all positions. Wait in each position for approximately 3 seconds
    • Low level (topping up)
      • Top up with oil through dipstick pipe
    • High level (overfilling)
      • Notes
      • Drain off oil
  • Pedal position sensor, clutch, replacing
    • Notes
    • Removal
      • Clutch pedal position sensor
    • Installation
      • Clutch pedal position sensor