Component Specifications
The component specification gives the value of the component when the connector is disconnected. Where no value is given, it is not possible to measure a relevant value at the component.
The figure within the brackets indicates the terminal pin on the component to which the value refers.
| Designation | Type | Supply voltage | Value | Miscellaneous |
| Air conditioning (A/C) relay | Mechanical relay | 12V (#1) | Approximately 70 Ω (coil) | |
| A/C pressure sensor | Absolute pressure sensor | 5 V (#3) | - | |
| Air conditioning (A/C) pressure switch | Pressure switch (Pressostat) | 12 V (#2) | 0 Ω at air conditioning (A/C) off | - |
| Brake lamp switch | Position switch | 12 V (#1) | The switch is closed when the pedal is depressed (#1-#2) | |
| Fuel temperature sensor | NTC resistor | 5V (#3) | 5896 Ω at 0 °C 3792 Ω at 10 °C 2500Ω at 20 °C 1707Ω at 30 °C 1175 Ω at 40 °C (#1-#2) |
Integrated in the fuel pressure sensor |
| Fuel pressure sensor | Piezoresistive pressure sensor | 5V (#3) | - | |
| Engine cooling fan (FC) control module | - | 12 V (#2) | - | |
| Evaporative emission system (EVAP) valve | Electromagnetic valve | 12 V (#1) | 17-24 Ω at 20 °C (#1-#2) | |
| Accelerator pedal (AP) position sensor | Electronic pedal sensor with two output signals, PWM and a linear analog signal | 5 V (#1) 12 V (#6) | - | |
| Throttle unit | Electronic throttle control module with two integrated potentiometers and a damper motor | 5 V (#3) | 1.2-3.5 Ω (terminals #1-#4 motor winding). 1000-1500 Ω (terminals #2-#3 Parallel connection of potentiometers 1 and 2). Approximately 820 Ω when the throttle is closed. Approximately 1580 Ω at wide open throttle (terminals #2-#6 potentiometer 1). Approximately 1480 Ω when the throttle is closed. Approximately 500 Ω at wide open throttle (terminals #2-#5 potentiometer 2) |
- |
| Fuel injector | Electromagnetic injector valve | 12 V (#1) | Approximately 12 Ω at 20 °C (terminal #1-#2) | |
| Camshaft position (CMP) sensor | Magneto-resistive sensor | 5 V (#1) | - | |
| Knock sensor (KS) | Piezo electric component | - | Greater than 1 MΩ (terminal #1-#2 front knock sensor (KS). Greater than 1 MΩ (terminals #3-#4 rear knock sensor (KS) |
Separate signal ground for the knock sensors (KS) |
| Clutch pedal switch | Position switch | 12 V (#1), ground terminal (#2) | - | Closed at 75% pressed down. |
| Charge pressure sensor | Absolute pressure sensor | 5 V (#3) | - | |
| Preheating front heated oxygen sensor (HO2S) | PTC resistor | 12 V (#3) | 2.6-3.4 Ω at 20 °C (#3-#4) | |
| Preheating, rear heated oxygen sensor (HO2S) | PTC resistor | 12 V (#1) | Approximately 9 Ω at 20 °C (#1-#2) | |
| Mass air flow (MAF) sensor | - | 12 V (#2) 5 V (#4) |
- | |
| Air temperature sensor, intake | NTC resistor | 5 V (#3) | 5886 Ω at 0 °C 3791 Ω at 10 °C 2510 Ω at 20 °C 1715 Ω 30 °C (#1-#2) |
Integrated in the boost pressure sensor |
| Leak diagnostic unit | Consists of an air pump, an electromagnetic valve and an internal heating element (PTC resistor) | 12 V (#4) | Approximately 118 Ω (terminals #1-#4 pump motor winding) 27.9 -34.1 Ω (terminals #3-#4 Valve coil) |
|
| Engine coolant temperature (ECT) sensor | NTC resistor | 5 V (#1) | 15040 Ω at -20 °C 2450 Ω at 20 °C 318 Ω at 80 °C (#1- #2) |
|
| Oil pressure switch | Pressure switch (Pressostat) | 12 V (#1) | Grounded in the cylinder block. Closed switch when the oil pressure is low | |
| Camshaft reset valve | Electromagnetic valve | 12 V (#1) | 3-5 Ω (#1-#2) | |
| Flywheel sensor | Engine speed sensor | - | 125Ω (+/- 17 Ω) at 20 °C (#1-#2) | |
| System relay | Mechanical relay | 12V (#1) | Approximately 80 Ω (coil) | |
| Starter relay | Mechanical relay | 12V (#1) | Approximately 80 Ω (coil) | |
| Turbocharger (TC) control valve | Electromagnetic valve (3 way) | 12 V (#1) | 23 Ω (+/- 1, 2 Ω) at 20 °C (#1-#2) |