Engine Speed (Rpm) Sensor
The engine speed (rpm) sensor provides the engine control module (ECM) with information about the speed and position of the crankshaft. The engine control module (ECM) is able to use the signal from the engine speed (rpm) sensor to determine when a piston is approaching top dead center.
The signal from the engine speed (rpm) sensor is also used to check the engine for misfires. For further information, see: MISFIRE DIAGNOSTIC
The impulse sensor is located on the engine's flywheel side, pointing forward. The sensor is inductive with permanent magnet. When the flywheel/drive flange plate passes the impulse sensor, an alternating voltage is induced in the sensor. The generated voltage and frequency increase when the engine speed increases.
The signal varies between 0.1-100 V depending on the engine speed (rpm).
The Engine Control Module (ECM) is able to determine the engine speed (rpm) by counting the number of holes per time unit. When the reference position passes the engine speed (rpm) sensor, the voltage and frequency drop momentarily to zero, even though the engine is still running. This allows the engine control module (ECM) to determine the position of the crankshaft.
If the signal from the engine speed (rpm) sensor is incorrect or missing, the control module will use signals from the camshaft position (CMP) sensor.
The engine speed sensor can be diagnosed by the engine control module (ECM) and the sensor signal (engine speed) can be read out.