Connecting The Breakout Box To The Abs Control Module
Courtesy of VOLVO CARS CORPORATION
- Ignition off
- Expose the ABS control module. See PREPARATIONS FOR REPLACEMENT
- Disconnect the ABS control module: First press in the catches on the rear of the cover (towards the wheel arch). Then carefully turn the cover upwards so that the lock catches release
- Check the control module and control module connectors to ensure that the male and female terminals are undamaged and secure (cannot be pressed in). Check that the cables to the female terminals are secured to the terminal pins
- In particular, check the terminal pins relevant to the diagnostic trouble code (DTC) / symptom. See SIGNAL SPECIFICATION, ABS CONTROL MODULE
- Connect adapter
see 9511354
to the control module connector (wiring side). Connect breakout box
see 9511428
to the adapter
- The breakout box is designed to facilitate reading off the control module input and output signals when the control module is connected; and cable and component resistance when the control module is disconnected. The use of a breakout box reduces the risk of accidental short-circuits and damage to the connector pins.